Carton Contents; Installing The Blades; Removing The Blade - AGP CG150 Original Instruction

CARTON CONTENTS

1.
Wall Chaser Machine
2. 2 Blade Spacers Set: 15mm, 10mm, 6mm (x2), 4mm
3.
5 Blade Spacers Set: 3.1mm (x5)
INSTALLING THE DIAMOND BLADES AND ADJUSTING THE GROOVE WIDTH

INSTALLING THE BLADES:

1.
Unplug the machine and push the limit pin to release the base and allow it swing down and out of the
way.
2.
Place the inner blade in position directly on the arbor making sure the direction of rotation arrow of the
blade and the arrow on the machine are in the same direction.
3.
Place as many spacers as necessary to achieve the desired groove
width. They are in sizes 15, 10, 6 (x2) and 4mm. There is also a set of
5 spacers of thickness 3.1mm for mounting 5 blades.
4.
Place the outer blade in position.
5.
Place all of the remaining spacers from the 2 blade spacer set on
top of the outer blade (so that the arbor may be tightened).
6. Place the tool-free arbor screw in position.
7.
If you are mounting 5 blades, start with the first blade directly on
the arbor, then one 3.1mm spacer and alternate blade and spacer
until all are in place. Then add enough spacers to fill the arbor and
add the arbor screw.
8.
Flip up the tab on the arbor screw and screw it in tightly. It may be
helpful to wear gloves and grab the blade to immobilize it while
tightening the arbor screw. Once tight, flip the tab back down.
9. When closing the base, ensure that the spring is properly
positioned in its socket in the base, then press the limit pin to allow
the base to close.
NOTE: Use blades that have an arbor bore which can fit, and that are rated for the machine's maximum
rated speed or higher.

REMOVING THE BLADE

Removal is the opposite of installing the blade.
GB
Inner Blade
7
Tab
Tool-Free Arbor Screw
Outer Blade
Spacers