AGP CG150 Original Instruction page 11

GB
remove the screw to release each brush cap.
Pull back on the carbon brush springs to release the tension. Unscrew the
screw holding the carbon brush lead. Then pull out the brush.
Repeat for the other side. To reassemble reverse the procedure.
NOTE: To reinstall the same brushes, first make sure the brushes go
socket head limit screws
back in the way they came out. Otherwise a break-in period will occur
that will reduce motor performance and increase brush wear.
If the replacement of the power supply cord is necessary, this has to be done by the manufacturer or
their agent in order to avoid a safety hazard.
WARNING: All repairs must be entrusted to an authorized service center. Incorrectly performed repairs
could lead to injury or death.
11