Electrical Connection - AGP CG150 Original Instruction

recommends that this tool NOT be modified and/or used for any application other than for which it was
designed. If you have any questions relative to its application DO NOT use the tool until you have written
the manufacturer and have been advised.
17. Only use the machine for dry cutting in stone, concrete or masonry.
18. Use the auxiliary handles supplied with the tool. Loss of control can cause personal injury.
19. Use a residual current device (PRCD) (not included) to protect from current surges.
20. Keep power supply cord clear from the working range of the machine. Always lead the cable away
behind you.
21. Immediately switch off the machine if unusual vibrations or if other malfunctions occur. Check the
machine in order to find out the cause.
22. Only use and store diamond blades according to the Manufacturer's instructions.
23. Pay attention to the dimensions of the blades. The diameter of the center bore must engage the arbor
without play. If not use any necessary reduction pieces or adapters (supplied with the blade) to ensure a
proper fit.
24. Take care to avoid hidden electric lines, gas and water pipes. Check your working area, e.g. with a
metal detector before commencing work.
25. The dust that arises when working with this tool can be harmful to health. Use a dust absorption
system and wear a suitable dust protection mask and remove deposited dust with a vacuum cleaner.

ELECTRICAL CONNECTION

The network voltage must conform to the voltage indicated on the tool name plate. Under no circumstances
should the tool be used when the power supply cable is damaged. A damaged cable must be replaced
immediately by an authorized Customer Service Center. Do not try to repair the damaged cable yourself. The
use of damaged power cables can lead to an electric shock.
INTRODUCTION
This saw is designed exclusively for the creation of masonry grooves (parallel double cuts in concrete, masonry
and stone) for the purpose of placing water, electric or gas conduits. The machine is designed to use a pair
of parallel diamond blades (not included) . This machine should not be used for cutting other materials. The
machine should not be converted or modified, e.g. for any other form of use, other than as specified in these
operating instructions. The user shall be liable for damages and accidents due to incorrect use.
UNPACKING
Carefully remove the tool and all loose items from the container. Retain all packing materials until after you
have inspected and satisfactorily operated the machine.
NOTE: An appropriate dry diamond blades (not included) must be mounted to the machine before
operating.
GB
6