New Signature Pin Kit; Components Of The New Signature Pin Kit - Assa Abloy Sargent Signature Series Information And Field Service Manual

Signature Series
®
Signature Pin Kit
8
SARGENT has developed the Signature Series cylinder to be very simple to maintain and service. In keeping with
this concept, SARGENT has a pin kit (catalog part #437S) and tools to assist in the field servicing of the Signature
cylinder.
Components of the Signature Pin Kit
The pin kit contains 100 each of all the standard pins and springs required to accomplish pinning the master keying of
the removable core cylinder. It also contains the necessary tools for assembling Signature featured cylinders.
When rekeying 10-6300 Signature Removable Core Cylinders, 437 RC/UL Rekeying Kit is needed in conjunction
with 437S.
SARGENT created two types of barrel loading rods (part #13-1034, 13-1035). These followers are uniquely
configured at each end to accommodate the different barrel configurations for the different types of Signature
cylinders (mortise, rim, cylindrical).
PIN 13-1035
The loading rods have also been machined to simplify the loading of the Signature cylinder outer body with driver
pins and springs (a standard part of the master keying process).
A spring depressing tool (part #13-1138) and a transfer knife (part #13-1037) are included to assist in transferring
DETERMINE STACK HEIGHT OF DRIVERS. SELECT
the driver and spring loads to the Signature cylinder body.
CORRECT PINS FOR EACH DRIVER CHAMBER. INSERT
PINS INTO CORRECT HOLE LOCATIONS IN LOADING ROD.
(START BY FILLING THE HOLE CLOSEST TO THE
CYLINDER BODY).
There is a set of tweezers with tips specially designed for
picking up cylinder pins.
USE SPRING BLADE TO COMPRESS SPRINGS. (SPRING
BLADE MUST BE FLUSH WITH LOADING ROD).
The blocking bars (part #13-0985 and 13-1109) and blocking bar springs (part #13-0986) are part of the
Signature pinning kit.
6
1-800-727-5477 • www.sargentlock.com • A7438F
LOAD SPRINGS INTO LOADING ROD HOLES.
13-1138
There is a field service tool (part #13-3916) that
has been included to assist in loading or re-orienting
the blocking bars.
PIN 13-1034
SLIDE PIN LIFT BLADE INTO LOADING ROD. (THIS WILL
LIFT PINS INTO CYLINDER BODY PIN CHAMBERS).
REMOVE CAP FROM SERVICE TOOL BASE BY PRESSING
SIDES OF CAP TO RELEASE SNAPS. INSERT CYLINDER
PLUG WITH KEY INTO BASE OF SERVICE TOOL.
PIN
13-1037