Maintenance; Shim Kit Option - Assa Abloy Corbin Russwin ED2400 Series Installation Instructions Manual

ED2400 & ED2400(A) Series Surface Vertical Rod
Exit Devices
Installation Instructions
2 General Information, continued
d

Maintenance

1. Periodically remove covers and coat mechanisms with a silicone-based lubricant. This is
particularly required in corrosive environments for proper product function.
2. Check mounting fasteners periodically. Retighten if found loose. Apply screw locking compound
(available at automotive part stores) or change part fasteners if screws continue to back out.
3. Periodic checks (and adjustments) of strikes are required to compensate for changes in the
opening (e.g. door sagging).
e

Shim Kit Option

867F508 Black Finish
• Kit consists of (2) Latch Head Shims (Device Cover seats on shim) and (2) End Clamp Shims (End
Cap seats on shim), (2) Top and Bottom Latch Shims (Bolt Case Mounting Plates seat on shim),
and (4) Rod Guide Shims.
• Each shim is 1/8" (3.2 mm) thick. More than two shim thicknesses 1/4" (6.4 mm), require longer
device mounting screws (not included)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
6
FM572 10/22