Blocking Bar Configuration - Assa Abloy Sargent Signature Series Information And Field Service Manual

Signature Series
®

Blocking Bar Configuration

7
SARGENT's Signature cylinder contains two (2) blocking bars.
The bar is placed so that the witness mark side of the bar is either toward the keyway broaching or away from the
keyway broaching.
GUIDE TO OFFSET BAR ORIENTATION
The position of the bars is determined by the last (seventh) digit of the Signature code pattern
stamped on the keys to be used.
There are currently two sets of configurations (positions) assigned by the factory for a
Signature code pattern. They are identified by the digit 4 or 2 as the seventh or last
character of the Signature code pattern.
See the illustration below for the proper orientation of the bars.
If necessary, reinsert the four blocking bar springs (two for each blocking bar or one for each
end of a blocking bar) and then the bars (in the correct configuration) as illustrated below.
2
4
5
A7438F • 1-800-727-5477 • www.sargentlock.com