Procedures - Honeywell SmartLine SLG 700 User Manual

Procedures

Step – 1: Determine the wire type of the wire probe, multi-twist or single twist:
Step – 2: Determine the sensor firmware version of the transmitter (the procedure will vary
depending on the user interface. Consult the User's Manual, the HART Manual, or the
FOUNDATION Fieldbus Manual. See references at the front of this manual.
a) 1.000000/1.000100: a change of probe type to multi-twist wire is not supported. The
transmitter must first be upgraded to a more recent release then the instructions
applicable to that release will apply.
b) 1.010000: a change of probe type to multi-twist wire is supported. Either a HART or
FF user interface is required to make the appropriate settings change.
c) 1.020000 and higher: a change of probe type to multi-twist wire is supported with all
interfaces.
Revision 8
Multi-twist
SLG 700 SmartLine Level Transmitter User's Manual
Single-twist
Page 143