Figure 5-13 - No Trimming Zones On Outer Tube And Inner Rod - Honeywell SmartLine SLG 700 User Manual

Step – 4: The inner rod of a coaxial probe is constructed out of 1.0 m rod segments. If the coaxial
probe is under 1.0 m long, there will only be one rod. Otherwise, there will be at least one rod
segment and a single rod end segment. The end segment will have only one threaded end.
Determine how many rod segments need to be removed to complete the trimming operation.
Use two 7 mm wrenches to unscrew the rods from each other, taking care not to misplace the lock
washer and M5 x 20 mm stud holding the rods together. If only a small length of the probe
requires trimming, only the end segment of the rod will need to be removed from the assembly.
Step – 5: Mark and trim the relevant outer tube and rod segments. Avoid trimming the coupler
region of the outer tube and internal thread region of the inner rod (flat area). Refer to Figure 5-13.

Figure 5-13 - No Trimming Zones on Outer Tube and Inner Rod

Step – 6: Drill a 6.0 mm hole through the end of the outer tube at location shown in
Figure 5-14.
SLG 700 SmartLine Level Transmitter User's Manual
Page 148 Revision 8