Honeywell SmartLine SLG 700 User Manual page 128

<Return>
Ampl Tracking
Location
Reflectn Model
Width
Attenuation
Gain
Obj Fin Thrshld
<Return>
Trim Zero
DAC Trim
(HART only)
Trim Span
Note: Loop
must be
removed from
Automatic
Control
Set DAC Normal
<Return>
Page 112
Enabled
Disabled
Process Conn
Surface
Interface
Probe End
Saturated Steam
####
##.##
######
#.#
This selection will calibrate the loop zero
output to 4.000 mA.
Connect a current meter to the transmitter to
monitor the loop output.
Note: The TEST +/- terminals should not be
used to trim the transmitter.
Press Enter to set the loop output to 4mA.
When the prompt "Enter reading" appears,
enter the value shown on the current meter
(in milliamps) and press Enter again. The
transmitter adjusts the DAC output to 4mA.
This selection will calibrate the loop span
output to 20.000mA
Connect a current meter to the transmitter to
monitor the loop output.
Note: The TEST +/- terminals should not be
used to trim the transmitter.
Press Enter to set the loop output to 20mA.
When the prompt "Enter reading" appears,
enter the value shown on the current meter
(in milliamps) and press Enter again. The
transmitter will adjust the DAC output to
20mA.
This selection allows the loop to be returned
to its Normal mode (Automatic Control) after
performing the Trim operation.
SLG 700 SmartLine Level Transmitter User's Manual
Improved level tracking for
difficult conditions or
uncertain medium
attenuation.
Reflection model location
Width of model in mm.
Attenuation of the model.
Gain of model.
Objective function threshold
of the model.
Press  to enter menu
selection.  and  to
select number.
 to enter and shift to
next digit
Press  to enter menu
selection. Scroll to Set
DAC Normal
Press  to initiate
Press  to enter
menu selection. 
and  to select
from list.  to
enter.
Press  to enter
menu selection. 
and  to select
number.  to
enter and shift to
next digit
Revision 8