Panasonic SF4B V2 Series Instruction Manual page 74

<Timing chart>
ON
Muting
sensor A
OFF
ON
Muting
sensor B
OFF
ON
Muting
sensor C
OFF
ON
Muting
sensor D
OFF
ON
Muting function
OFF
Light
Light
received
received
Light
status
blocked
ON
Control output
(OSSD 1 / 2)
OFF
1RWH 7KLV LV ZKHQ WKH PXWLQJ ODPS GLDJQRVLV IXQFWLRQ LV YDOLG ,I WKH PXWLQJ ODPS GRHV QRW OLJKW XS HYHQ LI  VHF
is passed, the muting function becomes invalid. When the muting lamp diagnosis function is invalid, the
muting function becomes valid 0.05 sec. after the input conditions of the muting sensor A (C) and B (D)
ZHUH VDWLV¿HG
<Reference>
It is possible to set the muting function into invalid per beam channel respectively and to specify the
input order of the muting input A and B to be set into valid by using the handy controller (SFB-HC) (op-
tional).
It is recommended that two muting lamps should be connected in parallel. In this case, take care not to
exceed 10W.
73
0.03 to under 3 sec.
0.05 to 1 sec. (Note)
© Panasonic Industriar Devices SUNX Co., Ltd. 2012 ME-SF4BV2-05
14ms or less