Advertisement
PLA1000
STEP 1
BE CAREFUL TO ASSEMBLE ALL COMPONENTS IN THE
SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware FIRST. wrench tighten all hardware at
the END of step 1F. some components may be pre-assembled.
1A.
attach Base Frame (B) to Base Crossmember (A) using:
2 - (#1) m12x80mm hex head bolt
4 - (#5) m12 flat washer
2 - (#7) m12 nylon lock nut
1B. Attach Base Crossmember (A) to the Base frames of
the Rack (L) using:
4 - (#1) m12x80mm hex head bolt
8 - (#5) m12 flat washer
4 - (#7) m12 nylon lock nut
2 - (H) Steel Plate
NOTE:
Please refer to the drawing for correct bolt hole locations for
Base Crossmember (A). The bolt holes are 3rd & 5th holes from
the back end of the Base Frame of the Power Rack.
1C.
Attach Chrome upright (C) to Base frame (B) using:
the Rack (L) using:
2 - (#1) m12x80mm hex head bolt
4 - (#5) m12 flat washer
2 - (#7) m12 nylon lock nut
1D. Insert Sliding Carriage (D) onto Chrome Upright (C).
1E. Attach Top Frame (E) to Rear Crossbar (N) using:
2 - (#1) m12x80mm hex head bolt
4 - (#5) m12 flat washer
2 - (#7) m12 nylon lock nut
1F. Attach Top Frame (E) to Chrome Upright (C) using:
2 - (#1) m12x80mm hex head bolt
4 - (#5) m12 flat washer
10
Advertisement
