Advertisement
PLA1000
STEP 2
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware FIRST. wrench tighten all hardware
at the END of step 2F. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
2A. Route Top Cable (#17) and install four Pulleys (#16)
as shown in step 2 drawing using:
4 - (#3) m10x45mm hex head bolt
8 - (#6) m10 flat washer
4 - (#8) m10 nylon lock nut
2B. Attach Steel Chain (#19) and Snap Link (#9) to the
eyelet end of the Top Cable (#17)
2C. Attach Snap Link (#9) to Sliding Carriage (D)
2D. Route Low Cable (#18) and install three Pulleys (#16)
as shown in step 2 drawing using:
1 - (#2) m10x65mm hex head bolt
2 - (#3) m10x45mm hex head bolt
6 - (#6) m10 flat washer
3 - (#8) m10 nylon lock nut
2E. Attach Steel Chain (#19) and Snap Link (#9) to the
eyelet end of the Low Cable (#18)
2F. Attach Snap Link (#9) to Base Frame (B)
12
Advertisement
