Double-Jointed Head Support Only: Installing The Backrest; Mounting The Backrest - Dentsply Sirona Sinius Installation Instructions Manual

4 Installation
4.13 Double-jointed head support only: Installing the backrest
58
NOTE
Risk of damage
When fastening connectors X10 / X16 with cable ties be careful not to
fasten cable harness L323/L321 along with them, as doing so would
restrict the length of the loop.
4.13 Double-jointed head support only: Installing the
backrest
4.13.1

Mounting the Backrest

NOTE
Possible malfunctions:
Screws that are not tightened can cause problems when moving the
headrest in and out.
➢ Tighten all screws firmly.
1. Loosen the 2 screws (A) (5 turns).
2. Unscrew the 4 upper screws (with washers) from the sword.
3. Slide the backrest (C) underneath the screw heads of the lower
screws (A) from above.
4. Screw the backrest tight with the 4 upper screws (B) (with washers).
5. Retighten the 2 lower screws (A).
Installation Instructions Sinius / Sinius CS / Sinius TS
D3561.031.01.15.02 07.2018
Dentsply Sirona
63 22 627 D3561