[Network] Menu - Panasonic AG-CX350 Operating Instructions Manual

t The setting is fixed to [REC RUN] when the [SYSTEM] menu → [SUPER SLOW] → [ON] is set.
t The setting is fixed to [FREE RUN] when the [RECORDING] menu → [PRE REC] → [ON] is set.
t The setting is fixed to [FREE RUN] when the [RECORDING] menu → [2 SLOTS FUNC.] → [BACKGR REC] is set.
t The setting is fixed to [REC RUN] when the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is set.
[DF/NDF]
Sets the count method for the time code generator.
Enabled only when the recording frame frequency of the [SYSTEM] menu → [REC FORMAT] is set to 59.94i/59.94p/29.97p.
[DF]
[NDF]
(Factory setting: [DF])
@
NOTE
t The setting is fixed to [NDF] when the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is set.
[UB MODE]
Selects the user bits mode. User bits information is recorded in the clip. Also, it is output as LTC UB, VITC UB of the SDI signal.
[FRAME RATE]
[USER]
[TIME]
[DATE]
[TC]
[CLIP NAME]
(Factory setting: [USER])
[TC IN/OUT SEL]
Sets the input/output of the <TC IN/OUT> terminal.
[TC IN]
[TC OUT]
(Factory setting: [TC IN])
[TC OUT REF]
Sets the output delay of the time code that is output from the <TC IN/OUT> terminal.
[RECORDING]
[SDI OUT]
(Factory setting: [RECORDING])
[REC COUNTER]
Sets operation of the counter for recording.
[TOTAL]
[CLIP]
(Factory setting: [TOTAL])
[TIME STAMP]
Selects whether to superimpose the date and time on videos that are shot. The display for the year, month, and day follows the [DATE FORMAT]
setting.
[OFF]
[DATE]
[TIME]
[DATE&TIME]
(Factory setting: [OFF])

[NETWORK] menu

Sets the setting regarding the network function.
[DEVICE SEL]
Select the device that connects external equipment (computer, etc.) to the camera.
The camera may restart when the setting is changed.
Chapter 4 Operation — Menu settings
Uses the drop frame mode.
Uses the non-drop frame mode.
Selects the image information (such as frame rate) of the camera.
Selects the user bits set in [UB PRESET].
Selects the local time. (hh, mm, ss)
Selects the local date and time. (YY, MM, DD, hh)
Records the time code value as user bits.
Records the value that CAM INDEX (one character) and CARD COUNT (three-digit number) both converted to ASCII
character code.
Only enabled when the [SYSTEM] menu → [FILE FORMAT] → [MOV] is set.
Sets to the time code input.
Sets to the time code output.
Outputs the recording time code without delay. This is used when performing simultaneous recording on two cameras with
the time code of this camera as the master.
Matches to output image from the <SDI OUT> terminal. Outputs without delay when video is not output from the <SDI OUT>
terminal.
Performs continuous counting until reset using the <RESET> button.
Clears the counter value at the start of recording and counts the time for each recording.
Does not superimpose the date and time.
Superimposes only the date.
Superimposes only the time.
Superimposes the date and time.
– 90 –