ProMinent DULCOMETER D1C Operating Instructions Manual page 12

8 Complete Operating Menu / Overview
All parameters of the controller can be set in the complete operating menu (access see previous page). The
following overview shows the settings which can be selected:
0.60
auto.:
mea. val 0.60 ppm
feed fwd:
ctrl out:
w:
calibration ClO
zero p.:
slope:
6.50 mA/ppm
measuring range
setting ?
measured value
setting ?
correcting value
setting ?
pumps
setting ?
relays
setting ?
limits
setting ?
servomotor
setting ?
control
setting ?
12
Permanent display 1
ppm
30.0 °C
Permanent display 2
70 %
only with control
59 %
0.60 ppm
(w = setpoint)
2
4.0 mA
Only with temperature correction
Only with pumps
Only with limit value
relay, solenoid relay
or servomotor
Only with
servomotor
Only with control
Number and scope of setting menus
depends on the device.
Access to setting menus can
be blocked with access code.
Only with
feed forward ctrl.
setting ?
feed forward control
Only with mA output
mA output 1
setting ?
Only with 2 mA outputs
mA output 2
setting ?
general setting
information
D1C2-ClO2-017-GB