Table of Contents
Advertisement
3.5 Connecting the Industrial PC
The mains plug must be disconnected
The power supply plug must be withdrawn!
Attention
Please read the documentation for the external devices prior to connecting them!
During thunderstorms, plug connector must neither be inserted nor removed!
When disconnecting a plug connector, always handle it at the plug. Do not pull the cable!
3.5.1 Connecting cables
The connections are located at the top side of the Industrial PC and are documented in the
Description
chapter.
When connecting the cables to the Industrial PC, proceed according to the following sequence:
•
Switch off all the devices that are to be connected.
•
Disconnect all the devices that are to be connected from the power supply.
•
Connect all the cables between the Industrial PC and to the devices that are to be connected.
•
Connect all data transfer cables (if present) to the appropriate plug-in receptacles of the data/
telecommunication networks.
•
Reconnect all devices to the power supply.
3.5.2 Check voltage rating and connect.
When fitted with 100-240 V
1. Check that the mains voltage is correct.
2. Insert the provided power supply cable into the Industrial PC's power supply socket. Then
connect it to a power socket with a grounded earth connection.
When fitted with the (optional) 24 V
1. Check that the external power supply is providing the correct voltage.
2. Insert the power supply cable that you have assembled into the Industrial PC's power supply
socket. Then connect it to your external 24 V power supply.
Use same type of rechargeable battery
If a 24 V UPS is installed, the same type of rechargeable battery must be used.
Attention
C5240
50/60 Hz power supply:
AC
power supply unit:
DC
Installation
Product
23
Advertisement
Table of Contents
