Troubleshooting
5 Troubleshooting
Fault
Nothing happens after the Industrial
PC has been switched on
The Industrial PC does not boot
fully
Computer boots, software starts,
but control does not operate
correctly
Memory device access error
The Industrial PC functions only
partially or only part of the time, e.g.
no or dark picture, but disk drive
responds when switching on
26
Cause
No power supply to the Industrial
PC
Other cause
CD in drive
Setup settings are incorrect
Other cause
Cause of the fault is either in the
software or in parts of the plant
outside the Industrial PC
Faulty device
Defective components in the
Industrial PC
Procedure
Check power supply cable
Call Beckhoff Service
Remove CD and press any
key
Check the setup settings
Call Beckhoff Service
Call the manufacturer of the
machine or the software
Call Beckhoff Service
Call Beckhoff Service
C5240