Figure 7-61 Removing The Knockout; Figure 7-62 Attaching The Base Plate To The Wall - NEC Xen Master System Hardware Manual

NEC Australia Pty Ltd
7 - 232
3.10.2 Wall Mounting using the Base Unit
1. Refer to Section 2 Preparing Multiline Terminal for
Adapter Installation, and perform Steps 1-5.
2. Press both sides of the base cover and turn it left to
remove it.
3. Rotate base cover 180° and install it again on the
Multiline Terminal.
4. Remove the shaded base plate knockout shown on
Figure 7-61 Removing the Knockout with nippers.

Figure 7-61 Removing the Knockout

5. Assemble the base plate and base cover.
6. As illustrated in Figure 7-62 Attaching the Base Plate
to the Wall, attach the base plate and base cover
assembly (wide end down) to the posts on the locally
provided and installed wall plate. Place locally
provided screws in the nodes on the base plate and
secure the assembly to the wall.
Posts

Figure 7-62 Attaching the Base Plate to the Wall

Xen Master & Xen Axis
Nodes
Nodes
Installing Optional Equipment