Figure 7-5 Removing Base Plate Dummy End; Figure 7-6 Cutting Dummy End In Half; Figure 7-7 Installing Adapter In Connector 1 - NEC Xen Master System Hardware Manual

System Hardware Manual
6. If an adapter is being installed, press tabs A and B to remove the
dummy end from the base plate as shown in Figure 7-5 Removing
Base Plate Dummy End.

Figure 7-5 Removing Base Plate Dummy End

7. Cut the dummy end in half as shown in Figure 7-6 Cutting Dummy
End in Half.

Figure 7-6 Cutting Dummy End in Half

8. If Adapter is installed in Connector 1 as show in Figure 7-7 Installing
Adapter in Connector 1, Install Dummy end B as shown in Figure 7-
8 Installing Dummy End B.

Figure 7-7 Installing Adapter in Connector 1

May 2001
7 - 195