Introduction - Barco DP2K SLP Series User And Installation Manual

6. Input & Communication
6.1

Introduction

General
The Input & Communication side of the DP2K SLP-series consists of a Local Keypad integrated into the projector housing and a
card cage with three slots. The rear side of the projector is equipped with a tail light which reflects the status of the projector.
Depending on the projector configuration the projector card cage is equipped with an ICP or ICMP. See illustration below. In case
an ICP is installed then an IMB, IMS, or HDSDI input module can be optionally inserted into the slot below the ICP. Note that all
information about the ICMP is gathered into one separated chapter: "ICMP", page 53.
1
Image 6-1
1 Projector status light.
2 Power ON/OFF switch.
3 Local keypad.
4 Barco Cinema Controller.
5 ICMP.
6 Input slot for IMB, IMS, or HD-SDI input module (in case no ICMP is installed.
7 ICP.
C
AUTION
the boards (except for the Cinema Controller) will result in an authorization request upon starting.
42
2 4
:
A unit may only be removed from the card cage by qualified service personnel. Removing one of
3
5
R5906847 DP2K SLP SERIES 02/06/2017
6 7