Barco DP2K SLP Series User And Installation Manual page 120

12. Color calibration
Influence of aspect ratio
The aspect ratio of the projected image could have a small influence upon the measured xy coordinates. Therefore, it's recom-
mended to save the xy coordinates per aspect ratio in separate MCGD files.
Color gamut calibration procedure:
1. Setup the ambient light conditions as it should be during the play out of the movie. (e.g. only the stairs and emergency exit
lighting is switched on).
Note: In an optimal setup less than 1% of light from any other source than the light from the projector should illuminate the
screen.
2. Sequentially measure and enter the xy coordinates of the three primary colors (red, green, blue) and full white. Use therefore
the Communicator. Go to Installation > Color calibration > Measure native colors. For detailed instructions see user guide of the
Communicator.
Caution: Ensure that the correct projection mode is selected: 2D or External 3D.
Caution: In case of 3D, measure the xy coordinates once through the left eye glass of the 3D goggles and once through the
right eye glass.
Tip: When using the wizard for white point calibration you can immediately proceed with the electronic correction.
3. Once all xy coordinates are measured and entered proceed by saving all measured values into a MCGD file.
Tip: Put in the MCGD file name the type of projection mode (2D or External 3D) and the aspect ratio (FLAT, SCOPE).
4. Map the MCGD file with the TCGD file. Use for that the Communicator. Go to Installation > Color calibration > Select target
colors. For detailed instructions see user guide of the Communicator.
5. In addition you can check if the corrected colors complies. Use therefore the Communicator. Go to Installation > Color calibration
> Verify corrected colors. For detailed instructions see user guide of the Communicator.
116 R5906847 DP2K SLP SERIES 02/06/2017