Lightspeed Redcat Access User Manual page 14

FCC Notice to user
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
•Reorient or relocate the receiving antenna (that is, the antenna for radio or
television that is receiving" the interference).
•Reorient or relocate and increase the separation between the
telecommunications equipment and receiving antenna.
•Connect the telecommunications equipment into an outlet on a circuit
different from that to which the receiving antenna is connected.
FCC RF Radiation Exposure Statement
For body worn operation, the portable part (Flexmike) has been tested and
meets FCC RF exposure guidelines.
This device must not be co-located or operating in conjunction with any
other antenna or transmitter. The changes or modifications not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.