Siemens SINAMICS Intelligent Operator Panel Operating Instructions Manual page 7

Changes in the manual
New Firmware Functions for V1.6.1
I/O Editor
The I/O Editor allows the direct configuration of the Digital
Inputs, Digital Outputs, Analog Inputs and Analog Outputs.
Daylight Saving Time (DST)
The DST function allows the user to configured the Control
Unit's real-time clock's daylight saving settings. For more
information see the "Extra" section in this manual.
User definable labels
The labels used on the status screen can be customised to
the user's own requirements.
Copying IOP parameter sets
This explains how to copy an IOP parameter set that is
saved onto an IOP to any number of other IOPs.
Copying "My Parameters" lists
This explains how to copy the "My Parameters" list that is
saved on an IOP to any number of other IOPs
Note
Firmware version restrictions
The functions described in the table above require firmware version V4.7 SP3 to be installed
in the Control Unit, all other functionality described in this manual is independent of the
firmware installed on the Control Units.
Intelligent Operator Panel (IOP)
Operating Instructions, 08/2015, FW V1.6.1, A5E00110011B AF
In Chapter
I/O Editor (Page 85)
Extras (Page 73)
User definable labels for the Status
screen (Page 22)
Custom parameter sets (Page 69)
Figure Configuration file location
(Page 67)
7