Siemens SINAMICS Intelligent Operator Panel Operating Instructions Manual page 51

6. Select the source of the command signal. In this example,
7. Select the actual digital input that will receive the
8. Setup any additional command signal inputs, or press
9. Select "Setpoint Parameter" to setup the setpoint signal
Intelligent Operator Panel (IOP)
Operating Instructions, 08/2015, FW V1.6.1, A5E00110011B AF
a digital input will be used.
command signal. In this example, it is digital input 0 (DI0).
Once the command signal input has been selected, the
IOP will return to the Status Word selection screen. This
allows the user to configure any other command signals
that may be required.
ESC twice to return to the "Custom Hand Mode" screen.
and value.
Control
5.1 Custom Hand mode
51