ABB i-bus KNX Product Manual page 163

®
ABB i-bus KNX
Parameters
7.9.4.1 —
Dependent parameter
Purge cycle in weeks
This parameter is only visible if the Automatically or triggered by object option has been selected.
Options:
The cycle for the automatic valve purging is set using this parameter.
The internal automatic purge timer starts directly after a download. The time is reset with each download.
The time is reset as soon as purging is completed. This can occur either through automatic purging or
via the group object Trigger purge.
After bus voltage recovery and download, the automatic purging cycle is restarted. The time before bus
voltage failure is not considered.
7.9.4.2 —
Dependent parameter
Reset purge cycle from control value greater than or equal to
Options:
Hereby, the purge cycle is reset to the set control value if it is exceeded.
1...4...12
Note
1...99 %
VC/S 4.x.1 | 2CDC508220D0211 Rev. A 161