ABB i-bus KNX Product Manual page 56

®
ABB i-bus KNX
Parameters
7.4.1.2.5 —
Dependent parameter
Actuate basic-stage cooling via
This parameter is not visible if the Basic-stage cooling parameter is deactivated.
Options:
The way the control value for the basic-stage cooling is to be output is set using this parameter.
•
Internal channel output (valve):If the internal output is selected, the control value is output directly on
this physical output where it is converted into the corresponding output signal.
In parallel to the actuation via the internal output, the control value is also output via the related
Status Control value Basic-stage cooling group object.
(Selection in the Type of heating/cooling system parameter: 4-pipe)
Depending on the selection in the Actuate basic-stage heating via parameter, it may not be possible to
select all options. If the valve output has already been selected here, it cannot also be used as an output
for the basic-stage cooling.
Example:
If the Internal channel output (valve) option has been selected as the output for the basic-stage heating,
this cannot be selected as the output for the basic-stage cooling.
(Selection in the Type of heating/cooling system parameter: 2-pipe)
In a 2-pipe system, heating and cooling are undertaken using the same device (e.g. cooling ceiling and
floor heating). Here it is possible that either the same valve is used for heating and cooling or that two
valves are used because the heat/cooling is output into the room via a dedicated heating/cooling coil.
For this reason it is therefore possible here to output the control values for heating and cooling on the
same output.
•
Group object: If Group object has been selected as the option, there is no actuation via any of the
internal outputs, instead the control value is only output on the bus.
The control value is output via the related Status Control value Basic-stage cooling group object.
Depending on the option selected in the Actuate basic-stage heating via parameter, this parameter may
have a different standard value.
The settings for the exact control parameters are made in the Temperature controller – Basic-stage
cooling parameter window.
The settings for the actuation of the control values via the valve output are made in the valve parameter
window.
54 2CDC508220D0211 Rev. A | VC/S 4.x.1
Internal channel output (valve)
Group object
Note
Note