Table of Contents
Advertisement
Remove the spring assemblies from the release handle pivot.
5
Installing the Release Handle Assembly
6
Place the springs on the release handle pivot, ensure that the spring arms are closest to the seat
carriage and the spring coil is the farthest from the seat carriage. One spring arm should be sitting
on the seat locking pin.
7
Place the seat carriage wheels underneath the other spring arm and secure the wheel to the
carriage with shoulder bolts and lock nuts.
Installing the Seat Carriage Assembly
8
Slide the seat carriage partially onto the seat rail.
Slide the seat carriage fully on the seat rail and all the way forward. Set the seat stop in its position.
9
10 Connect the flat ribbon cable to the heart rate cable in the seat rail and replace the cable clamp.
Secure the clamp with the screws removed earlier. Fully tighten.
11 Slide the seat carriage fully to back most position. Snap the water bottle holder onto the seat
carriage. Secure the water bottle to the carriage with the screw and washer removed earlier. Fully
tighten.
12 Slide the seat carriage fully to forward most position. Replace the end cap and fasten it to the
carriage with the hardware removed earlier. Fully tighten.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 55
Advertisement
Table of Contents
