Precor UBK13 Service Manual page 42

Figure 34: Generator Mounting Bolts
9 Remove the generator.
Installing a Generator
10 Place the generator on the frame, aligning the generator mounting holes with the frame mounting
holes.
11 Secure the generator to the frame using the four 5mm mounting bolts, nuts and washers; fully
tighten.
Figure 35: Generator Mounting Bolts
12 Connect the two generator connector cables, one directly to the generator and the other to the
cable extension connector.
Figure 36: Generator Cable Connectons
13 Thread the three mounting bolts through the idler pulley bracket and into the generator, only hand
tighten at this time.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 40