Top Cover Installation
13 Replace the top cover.
14 Secure the top cover with the two screw removed earlier.
Replacing a Primary Drive Belt
1
Remove the covers as per procedure,
Covers - RBK13
Removing the Primary Drive Belt
2
Slightly loosen the three idler pulley bracket mounting bolts.
3
Loosen the adjustment bolt lock nut.
4
Turn the adjustment bolt counter clockwise as required to remove the tension from the primary
drive belt.
Figure 12: Drive Belt Adjustment
5
Remove the primary drive belt.
Installing the Primary Drive Belt
6
Place the primary drive belt in its mounting position around the input pulley, under the idler pulley
and around the primary pulley.
7
Tension the primary drive belt as per procedure,
Replace the covers as per procedure,
8
Covers - UBK13
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Replacing the Covers - UBK13
(on page 21).
Replacing the Covers - RBK13
(on page 16).
(on page 16) or
Primary Belt Tension Adjustment
(on page 21) or
Replacing the
(on page 9).
Replacing the
Page 25