Table of Contents
Advertisement
Figure 39: Lower PCA Mounting Bracket
4
Remove the four screws that secure the lower PCA to the mounting bracket.
Figure 40: Lower PCA Mounting Screws
5
Remove the lower PCA and four stand-offs located underneath the PCA from the bracket .
Installing the Lower PCA
6
Set the lower PCA in the mounting bracket, the data connector should be on the right hand side of
the bracket.
7
Secure the lower PCA to the mounting bracket with the four screws and stand-offs removed earlier.
8
Set the lower PCA bracket in its mounting position and fasten it to the frame with the two screws.
9
Reconnect the wiring to the lower PCA as follows: two red load wires to M1, M8; red generator wire
to M3, white generator wire to M4; generator wire to M5; red battery wire to M6, Black battery
wire to M7; data cable to connector J2.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 43
Advertisement
Table of Contents
