Table of Contents
Advertisement
12 Replace the pop-pin knob.
Replacing a Seat Post
Component - UBK Only
Removing the Seat Post Pop-Pin
1
Remove the pop-pin knob; turn the knob counter clockwise to remove. Note: Sitting on the seat
while removing the knob will help prevent the pop-pin from rotating.
2
Remove the retaining ring.
Figure 47: Seat Post Pop-pin Retaining Ring
3
Pull up slightly on the seat post to relieve the pressure off the pop-pin. Pull the pop-pin out of the
frame.
4
The seat post is now unsupported, ease the seat post into its lowest position.
Removing the Seat Post
5
Lift the seat post until you see the window in the post, than lower the post so that only the top
portion of the window can be seen above the collar. Press on the seat post collar tabs located on
the left and right side of the seat post frame.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 48
Advertisement
Table of Contents
