Table of Contents
Advertisement
Installing a Crankarm
16 Place the crankarm onto the crankarm axle; ensure the crankarm is positioned 180° opposite the
other crankarm.
Figure 21: Crankarm Position
17 Thread the crankarm mounting bolt into the crankarm axle and fully tighten.
18 Install the pedal to the crankarm.
Pedal the bike for one minute and then re-tighten the crankarm mounting
bolt.Installing the Primary Drive Belt
19 Place the primary drive belt in its mounting position around the input pulley, under the idler pulley
and around the primary pulley.
20 Tension the primary drive belt as per procedure,
21 Replace the covers as per procedure,
Covers - RBK13
Replacing the Input Pulley and
Axle Assembly
Remove the covers as per procedure,
1
Covers - UBK13
2
Remove the left hand crankarm and pedal.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Replacing the Covers - UBK13
(on page 21).
Replacing the Covers - RBK13
(on page 16).
Primary Belt Tension Adjustment
(on page 16) or
(on page 21) or
(on page 9).
Replacing the
Replacing the
Page 31
Advertisement
Table of Contents
