Comparing A Single Parameter - LeCroy WaveMaster 8600A Operator's Manual

Touch the Summary View to enable a line of text
4.
shows concisely the status of your last waveform and keeps a running count of how many
sweeps have passed.
Touch inside the Pass If field, and select a Boolean condition from the pop-up menu.
5.
If you want to set up the test to end after a finite number of sweeps, touch the Stop Test
6.
checkbox. Then touch inside the After data entry field and enter a value, using the pop-up
numeric keypad.
Under "If", touch either the Pass
7.
upon your waveform's passing or failing the test.
Under "Then", touch the actions you want to occur: stop test, sound alarm, print result, emit
8.
pulse, or save the waveform. If you want to have the results printed and your scope is not
equipped with a printer, be sure that the it is connected to a local or network printer. See
Printing.
If you want to save your waveform automatically, touch the Save Setup. This will take you
9.
out of the current dialog and will open the "Save Waveform" dialog. See Saving and
Recalling Waveforms.
Test your Pass/Fail conditions by touching the Force Actions Once button. Press the
10.
Clear All button to quickly uncheck all checkboxes if you want to change your selections.

Comparing a Single Parameter

1. Touch Analysis in the menu bar, then Pass/Fail Setup... in the drop-down menu.
2. Touch a Qx tab; a setup dialog for that position will open.
3. Touch inside the Source1 field and select a source from the pop-up menu.
4. Touch inside the Condition field in the main dialog and select ParamCompare
5. Touch inside the Compare Values field and select All or Any from the pop-up menu
. By selecting All, the test will be true only if every waveform falls within the limit
that you will set. By selecting Any, the test will be true if just one waveform falls within the
limit.
242
or Fail button to set the actions to occur
that
.
WM-OM-E Rev I