Table of Contents
Advertisement
3. Touch inside the Source1 field and select an input waveform from the pop‐
up menu.
4. Touch inside the Measure field and select a parameter from the pop‐up
menu.
5. Touch the Trend button at the bottom of the dialog.
Track View
A Track View of a measurement parameter is a unique and specialized graph that is
time correlated to the signal being measured. The Track View applies to a single‐
shot acquisition and plots the variation of a parameter (such as width) for each
cycle in time‐correlated sequence with the waveform. Track View lets you locate a
problematic signal feature including width, period, amplitude, and more.
Set up a Track View by following the previous steps, except touch the Track button
at the bottom of the dialog.
JitterTrack View
A JitterTrack View is similar to a Track View but is applicable to a specialized set of
timing parameter measurements used to analyze cycle‐to‐cycle timing variation,
including clock jitter, and to aid in tracking the variation to its source. JitterTrack is
available with the optional XMAP or JTA2 WaveShape Analysis packages.
H
ISTOGRAMS
Creating and Viewing a Histogram
Note: The number of sweeps comprising a histogram is displayed in the bottom
line of the trace descriptor label.
Single Parameter Histogram Setup
F
M
ROM
EASURE
1. Touch Measure Measure Setup from the menu bar.
2. Touch the My Measure button.
3. Touch one of tabs P1 through Px.
4. Touch inside the Source1 field and select an input waveform from the pop‐
up menu.
WRXi-A-GSM-E Rev A
D
IALOG
G
S
ETTING
TARTED
M
ANUAL
55
Advertisement
Table of Contents
