To Set Up An Edge Trigger - LeCroy WaveMaster 8600A Operator's Manual

Vertical: Turn the Level knob
vertical threshold.
Turn this knob to adjust the level of the trigger source or the highlighted trace. Level defines the
source voltage at which the trigger will generate an event a change in the input signal that satisfies
the trigger conditions.
Alternatively, in the "Trigger" dialog, you can touch inside the Level field and type in a value, using
the pop-up numeric keypad. To quickly set a level of zero volts, touch the Zero Level button directly
below the Coupling field.
An arrow on the left side of the grid shows the threshold position. This arrow is only visible if the
trigger source is displayed.

To Set Up an Edge Trigger

Channel Setup
1. In the menu bar, touch Trigger, then select Trigger Setup... from the drop-down menu.
2. Touch the Edge trigger button
3. Touch inside the Trigger On data entry field and select an input from the pop-up menu:
4. Touch inside the Level data entry field
enter a value in millivolts or use the up/down buttons
decrease the value in increments of 1 mV. Or, touch one of the preset value buttons:
WM-OM-E Rev I
X-Stream Operator's Manual
in the TRIGGER control group to adjust the trigger's
under the Trigger tab.
. In the pop-up numeric keypad,
to increase or
103