Channel Buttons; Wavepilot Control Knobs; Wavepilot Control Buttons; Measure - LeCroy WaveMaster 8600A Operator's Manual

Volts/Div

Channel Buttons:

1, 2, 3, 4
Wavepilot Control
Knobs:
Position
Zoom
Position
Zoom
Wavepilot Control
Buttons:
Reset
Math

Measure

Analysis

Special Features
Buttons:
Auto Setup
Cursors
Default Setup
Drive Analysis
Serial Data
WM-OM-E Rev I
Adjusts the Volts/Division setting (vertical gain) of the channel selected.
Turns a channel on or off. These buttons activate the dialog that lets you
change the channel's setup conditions including coupling, gain, and
offset. They are used also to select multiple grids, to automatically set the
gain (FIND SCALE), or to automatically display a zoom of the signal.
Press twice to toggle the trace on and off.
Adjusts the horizontal position of a zoom trace on the display. The zoom
region is highlighted in color on the source trace.
Adjusts the horizontal zoom (magnification factor) of the selected zoom
trace.
Adjusts the vertical position of the selected zoom trace on the display.
Adjusts the vertical zoom (magnification factor) of the selected zoom trace
on the display.
Resets the zoom factors.
Provides access to the Math setup dialog.
Provides access to the Measure setup dialog.
Provides access to the Analysis setup dialogs.
Automatically sets the scope's horizontal timebase (acquisition system),
vertical gain and offset, as well as trigger conditions, to display a wide
variety of signals.
The center button calls up the "Standard Cursors" setup dialog. The other
two buttons control the placement of the cursors on your waveform.
Sets the scope's horizontal timebase (acquisition system), vertical gain
and offset, and trigger conditions to default settings.
This button is found on DDA instruments in place of Default Setup. When
pressed, it displays the DDA setup dialogs.
This button is found on Serial Data Analyzers in place of Default Setup.
When pressed, it displays the SDA setup dialogs.
X-Stream Operator's Manual
53