Ipsec - Planet VCG-1500WG-LTE User Manual

5.4.3 IPSEC

Object
Connection Mode
Remote Address
Transport Mode
Local Endpoint Type
Phase 1
Figure 5-4-3-1 iPSec Configuration
Description
Initiative Mode: Initiate connection from this side
Passive Mode: Wait for remote side connection
Server IP or domain name (compulsive to input)
Transport Mode: usually used when gateway connects server
Tunnel Mode: usually used when establishing tunnel between two gateways
Pass-through Mode: allow IPSec protocol to pass through
Network-to-Network: used communication between equipment of gateway and
equipment of server
Road Warrior: connect to server as mobile clients end
Subnet: It is subnet of both sides when working mode is Network-To-Network
Next-hop IP: When device is in LAN, then this IP is the IP address of gateway that the
device points to
IPSec Port: when starts L2tp at the same time, L2tp monitor port and L2tp default port is
1701
IPSec Identity: the identification supplied to the opposite side when connects
negotiation
If IPsec SA through consultation is established in the first stage, IPSec service for data
communication will be supplied.
Work Mode: Main and Aggressive mode
PFS: Precise forwarding secrecy. Avoid affecting the whole communication system
45
User's Manual of VCG-1500WG-LTE