Taylor-Dunn B0-210-36 Service And Replacement Parts Manual page 26

Lubrication
LUBRICATION AND FLUIDS CHART
Assembly Component
Front Axle:
2: King Pin
3: Ball Joint
4: Brake Pedal
5: Wheel Bearing
Brake Fluid:
Master Cylinder
Linkages:
Misc
Rear Transaxle:
7: Drain Plug (ref)
8: Level Plug (ref)
9: Fill Plug (GT)
9: Fill Plug (SD)
9: Fill Plug (B-200)
10: Motor Coupler
11:Fill/Level (SD Axle)
HAZARDOUS WASTE DISPOSAL
This vehicle contains various components and/or fluids that may be classified as hazardous waste.
This includes but is not limited to Lead, Acid, Oil, Grease.
The brake linings originally installed by the factory do not contain asbestos. However, since it is possible that
asbestos brake linings were installed as replacement parts, brake linings should be handled as hazardous
waste.
The requirements for disposal of hazardous waste vary by location. Consult your local regulations regarding
the proper disposal of hazardous waste products.
Page 26
# Capacity Lubricant
2 - NLGI Grade 2 lithium multi-purpose grease
4 - NLGI Grade 2 lithium multi-purpose grease
1 - NLGI Grade 2 lithium multi-purpose grease
2 - NLGI Grade 2 lithium high temp Bearing Grease
1 DOT 3, Meets or exceeds SAE J1703
3 - Multi-purpose spray lubricant
1 1.4-1.9 Liters SAE 80W90 Gear Oil
1 1.4 Liters SAE 80W90 Gear Oil
1 0.33 Liters SAE 30 Motor Oil
1 Part # 94-421-34 Moly Paste Grease
1 0.75 Liters SAE 80W90 Gear Oil
B-200 & B-210 Models
MB-210-13