Taylor-Dunn B0-210-36 Service And Replacement Parts Manual page 120

Suspension
FRONT OR REAR SPRINGS
WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
Note: If a left or right side spring is replaced, it is recommended to
replace the opposite side at the same time.
Note: When replacing the springs, replace one side and then the other
to avoid dropping the axle out of the vehicle.
Do not over torque the spring bolts on elliptical spring hangers.
The spring hangers must be allowed to pivot.
When replacing springs, inspect the hangers for signs of wear
and replace as needed.
Fully tighten the hanger bolts and the loosen so that the spring
and hangers can pivot with no play.
Trailing spring U-bolt should be tight enough so that the U-bolt
strap does not rattle.
Trailing spring U-bolts
Page 120
B-200 & B-210 Models
Typical Spring hanger
MB-210-13