Table of Contents
Advertisement
Item
3. Table Top Positioning
Foot Pedals
4. Down Pedal
5. Up Pedal
6. Table Lock Control
Buttons
7. Emergency Stop
Buttons
8. Detector Tray
Override
9. Optical pinch sensor
area
5495975-1EN Rev.9
© 2013-2017 General Electric Company. All rights reserved.
This pedal allows you to move the table in all directions: longitudinally and
transversely. This is known as a floating tabletop.
Press the pedal twice and hold down to move the table top.
The Down pedal lowers the table down.
Press the pedal twice and hold down to lower the table.
The Up pedal raises the table up.
Press the pedal twice and hold down to raise the table.
There are two lock buttons located on the right sides of the table, near the
head and foot of the table. They are used to prevent the table up-down
and tabletop movement. The lock is engaged when the button is lit.
There are two Emergency Stop buttons located on the left sides of the
table. These buttons are used to power off the table in an emergency.
Refer to
Chapter 4: General Information-Emergency Stop (p. 4-9)
information.
The Detector Tray Override is used for receptor placement if auto-tracking
fails.
The sensors detect a hand or other body part below the surface of the
table and lock the table movement to prevent injury. The system will sound
an audible tone when the finger pinch lock is activated.
Refer to
Digital Cassette Imaging in Extended Table Detector Tray(p. 8-56)
for more information.
Chapter 8: System Hardware Overview
Description
for more
8-60
Advertisement
Table of Contents
