Fingerprint Reader Assembly - HP Pavilion 13 Maintenance And Service Manual

Fingerprint reader assembly

Description
Fingerprint reader assembly, pike silver (includes bracket)
Fingerprint reader assembly, mineral silver (includes bracket)
Before removing the fingerprint reader assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the fingerprint reader assembly:
1. Disconnect the cable from the system board ZIF connector (1).
2. Lift to remove the bracket from the computer (2).
3. From the outside of the chassis, push the fingerprint reader module into the chassis (3), and then
remove the module and cable from the computer (4).
Reverse this procedure to install the fingerprint reader assembly.
Bottom cover on page
Battery on page 27).
25).
Component replacement procedures
Spare part number
L37373-001
L38041-001
35