Fingerprint Reader Assembly - HP ZHAN 66 Pro G1 Maintenance And Service Manual

Fingerprint reader assembly

Description
Fingerprint reader assembly (includes cable)
Fingerprint reader bracket (included in Bracket Kit)
Fingerprint reader insert (included in Plastics Kit; for use in models without a fingerprint reader)
Before removing the fingerprint reader assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in "Battery Safe mode"
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service doors
b. Hard drive
c. Keyboard
d. Top cover
Remove the fingerprint reader assembly:
1. Position the top cover upside-down.
2. If necessary, lift the tape from atop the bracket (1).
3. Slide the bracket toward the side of the top cover, and then lift it off the fingerprint reader board (2).
TIP:
44 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Service doors on page
(Hard drive on page
(Keyboard on page
(Top cover on page
A tool may be required to push and disengage the bracket.
(Battery Safe mode on page
28).
34)
37)
41)
Spare part number
L01091-001
L01051-001
L01084-001
27).