Lenovo Storage D1212 Hardware Installation And Maintenance Manual page 90

To fully close the top drawer, do the following:
1. Turn off the system and then disconnect the power cord from the electrical outlet.
2. Fully open the top drawer fully using the instructions in "Opening a Drawer " on page 84.
3. Remove all 42 drives on the top drawer, while leaving the bottom drawer closed.
4. Press and hold the latches of the top drawer, and then pull out the top drawer slightly. For the location of
the drawer latches, refer to Figure 85 "Drawer Latches" on page 86.
Note: Ensure that the top drawer is pulled out about 25-30 mm (0.98-1.18 inches) and the rear of the
top drawer is exposed.
5. Release the cable chain from the rear of the top drawer by lifting the retaining latch and sliding out the
bracket.
Figure 69. Releasing the cable chain
6. Further pull out the top drawer about 30-40 mm (1.18-1.57 inches).
7. Identify which DDIC has popped up in the bottom drawer.
8. Reach the pop-up DDIC by reaching out a hand behind the top drawer.
If you still cannot reach the pop-up DDIC, do the following:
a. Remove the front bezel from the right side of the chassis.
70
Lenovo Storage D1212/D1224/D3284Hardware Installation and Maintenance Guide