Gem Cli General Commands - Lenovo Storage D1212 Hardware Installation And Maintenance Manual

GEM CLI General Commands

The CLI commands in the following section are for general use, and can be issued without any possibility of
causing data loss or other serious problems.
change_password
Changes the password for the currently logged in user. The password is changed at the enclosure level, so
all ESMs use the updated login credentials on completion.
The command is interactive and the current password must be specified before a new password can be
specified.
Syntax:
change_password
Example:
0+02:58:35.445 M0 GEM> change_password
Enter Old Password:********
Enter New Password:*******
Reenter New Password:*******
password change success
0+02:58:55.822 M0 GEM>
cleardriveindicator
Stops displaying a drive location indication on the specified drive bay. The drive location indication is used to
aid in locating a drive bay for servicing.
Syntax:
cleardriveindicator <drive>
drive The 0-based ID of the drive bay for which the locate indication is to be halted
Example:
0+03:03:11.579 M0 GEM> cleardriveindicator 0
0+03:05:17.297 M0 GEM>
ddump
Displays all enclosure diagnostic information. The information from this command must be provided for both
ESMs when submitting problem reports.
Syntax:
ddump
Example:
0+03:18:10.897 M0 GEM> ddump
----------------------------------------------------------------------
batt_dump_regs
Diagnostic dump of the battery registers
Battery 1 - Not Present
Battery 2 - Not Present
Battery 3 - Not Present
Battery 4 - Not Present
...
255 | 0000000000000000 | 0000000000000000 | 0000000000000000 |
0+03:10:32.272 M0 GEM>
. 99
Chapter 7 GEM CLI Commands