Lenovo Storage D1212 Hardware Installation And Maintenance Manual page 91

b. Insert a flat head screwdriver into the slot nearby the bottom drawer and push the retaining arm up.
Figure 70. Pushing the retaining arm up
c. Open the bottom drawer until you can reach the pop-up DDIC.
CAUTION:
When the top and bottom drawers (with drives installed) open at the same time, ensure that the
rear of chassis is suitably fastened on the workbench. Otherwise, the chassis might fall down.
9. Remove the pop-up DDIC from the bottom drawer using the instructions in "Removing a DDIC " on page
86.
10. Reinsert the removed DDIC into the bottom drawer using the instructions in "Inserting a DDIC" on page
87.
11. Close the bottom drawer if you have opened it.
12. Reinsert the cable chain into the holder, and then close all cable clamps that have been opened.
Note: Ensure that the bundles of the cables are in the correct position and not pinched or trapped.
13. Push the top drawer inward until you hear a click and see the rear row DDIC slot aligning with the
chassis front.
14. Reinstall the 42 drives that you removed, and then close the top drawer fully.
.
Chapter 5 Troubleshooting and Problem Solving
71