Lenovo Storage D1212 Hardware Installation And Maintenance Manual page 123

Syntax:
help [[type] | [cmd]]
type
cmd
Example:
0+03:42:33.775 M0 GEM> help
Supported commands:
change_password
cleardriveindicator
ddump
ddumpo
exit
getboardid
getvpd
help
hid_set_ident
ipconfig
logcmt
logdump
logdumpnv
poweroffdrive
powerondrive
report_faults
reset_saved_zone_info
set_encl_id
set_zone_mode
setcanisterindicator
setdriveindicator
settime
ver
0+03:49:10.821 M0 GEM>
hid_set_ident
Sets or clears the locate indication on the enclosure Ops panel. The locate indication is used to aid in the
identification of the physical enclosure for maintenance.
Usage:
hid_set_ident <State>
The command classification to list
The specific command for which the usage shall be retrieved
To change Current User Password
Clears the drive indicator LED
System-wide diagnostic dump
Ordered system-wide diagnostic dump
To logout from the cli connection
Get this board ID and mode
List all VPD information
Displays command information
Set/clear enclosure identify mode
Set IP Configuration in VPD
Insert comment in logdump
Display logged msgs
Display Non-Vol logged msgs
Powers off a drive (includes spin-down)
Powers on a drive (includes spin up)
Reports all system-wide faults
Erases saved zone information from flash and resets the context with default values
Set enclosure ID
Change default configuration for zoning
Set/Clear the local canister indicator status
Set the drive indicator LED
Sets unit time
Version information
.
Chapter 7 GEM CLI Commands
103