Figure 77. Engaging a Drive Carrier Module in an Enclosure
Removing/Replacing 2.5-inch Drive Carrier Modules
The removal/replacement procedure for 2.5" drive carrier modules is basically the same as for 3.5" drive
carriers, except that the 2.5" drive carriers are mounted vertically.
To remove/replace 2.5-inch drive carrier modules, do the following:
1. Release the carrier handle, by pressing the latch in the handle downwards and insert the carrier into the
enclosure in the vertical position.
Important: Make sure that the carrier is positioned so that the drive is on the left side and the handle
opens from the top (see Figure 78 "2.5" Drive Carrier Module in Open Position" on page 82).
.
Chapter 6
Module Removal and Replacement
81