Replacing A Disk Drive In Carrier (Ddic); Removing A Ddic - Lenovo Storage D1212 Hardware Installation And Maintenance Manual

Figure 85. Drawer Latches

Replacing a Disk Drive in Carrier (DDIC)

Note: 5U enclosures only
This topic provides instructions on how to remove and insert the disk drive in carrier.

Removing a DDIC

1. Identify which drawer contains the drive to be replaced. If the drive number is known, the plan in Figure
86 "Drive Location" on page 86 can be used. If the drive has failed, the drive fault LED is lit amber on the
relevant drawer.
Figure 86. Drive Location
2. Open the relevant drawer using the instructions in "Opening a Drawer " on page 84.
3. Locate the drive to be replaced, either by using the drive plan (see Figure 86 "Drive Location" on page
86) or by looking for the amber LED on the drive that indicates a fault.
4. Slide the release button, as shown in the following figure.
5. Slide the top surface in the direction of the arrow until the latch releases, as shown in the following
figure. The DDIC should pop up slightly from the slot.
86
Lenovo Storage D1212/D1224/D3284Hardware Installation and Maintenance Guide