Led Lamps - PEUGEOT 2008 Handbook

Hide thumbs Also See for PEUGEOT 2008:
Table of Contents

Advertisement

Lighting and visibility
F Raise the lighting control stalk fully when
turning right.
If you forget to cancel the direction
indicators for more than 20 seconds, the
volume of the audible signal will increase if
the speed is above 37 mph (60 km/h).
Three flashes
Move the stalk briefly upwards or downwards,
without going beyond the point of resistance;
the corresponding direction indicators will flash
3 times.
This function can be used at any speed,
but it is particularly useful for changing
lane on fast roads.
Parking lamps
62
Vehicle side marking by illumination of the
sidelamps on the traffic side only.
F Within one minute after switching off the
ignition, operate the lighting control stalk up
or down, depending on the traffic side (for
example, when parked on the left, move the
lighting control stalk upwards; the right-hand
sidelamps come on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition.

LED lamps

They come on when the engine is started.
Depending on the country of sale, they are
used for:
-
daytime running lamps* in day mode and
sidelamps in night mode (they are brighter
when daytime running lamps),
or
-
sidelamps in day and night mode.
Daytime running lamps
Daytime lighting, compulsory in certain
countries, which comes on automatically when
the engine is started making the vehicle more
visible to other users.
This function is provided:
-
in countries where it is imposed by
regulations, by illumination of the dipped
beam headlamps with the sidelamps and
number plate lamps; this function cannot be
deactivated.
-
for other countries where it is provided,
by the use of dedicated lamps (LEDs); this
function can be activated or deactivated via
the vehicle configuration menu.
The lighting control stalk must be placed in the
0 or AUTO (day mode) position.
* This setting is done in the vehicle
configuration menu.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents