PEUGEOT 2008 Handbook page 42

Access
- Self-protection function
The system checks the deactivation status of
its components.
The alarm is triggered if the siren's battery,
central control unit or wiring is put out of
service or damaged.
For all work on the alarm system, contact a
PEUGEOT dealer or a qualified workshop.
Locking the vehicle with full
alarm system
Activation
F Turn the ignition off and exit the vehicle.
F Press the locking button on the
remote control.
The alarm monitoring system is
activated (armed): the red indicator
lamp in the button flashes once per
second.
After the locking button on the remote control
is pressed, the exterior perimeter monitoring
is activated after a delay of 5 seconds and the
interior volumetric monitoring after a delay of
45 seconds.
If an opening (door, boot, etc.) is incorrectly
closed, the vehicle is not locked but the exterior
perimeter monitoring will be activated after
45 seconds at the same time as the interior
volumetric monitoring.
40
Deactivation
F Press the unlocking button on
the remote control.
The alarm system is deactivated: the
indicator lamp in the button goes off.
Locking the vehicle
with exterior perimeter
monitoring only
Deactivate the interior volumetric monitoring
to avoid unwanted triggering of the alarm in
certain cases such as:
- leaving a pet in the vehicle,
- leaving a window partially open,
- washing your vehicle.
Deactivating the interior
volumetric monitoring
F Switch off the ignition.
F Within 10 seconds, press the button until
the red indicator lamp is on continuously.
F Get out of the vehicle.
F Immediately press the locking button on
the remote control.
Only exterior perimeter monitoring is activated:
the red indicator lamp in the button flashes
once per second.
To take effect, this deactivation must
be carried out each time the ignition is
switched off.
Reactivating the interior
volumetric monitoring
F Press the unlocking button on the remote
control to deactivate the exterior perimeter
monitoring.
F Press the locking button on the remote
control to activate all the monitoring
functions.
The red indicator lamp in the button once again
flashes every second.
Triggering of the alarm
This is indicated by sounding of the siren
and flashing of the direction indicators for
30 seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times in
succession.
When the vehicle is unlocked using the remote
control, rapid flashing of the indicator lamp
in the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops
immediately.